Fuse Panel B -Sb- In Engine Compartment E-Box, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying E-Box Bolts & Cover

Courtesy of AUDI OF AMERICA, LLC

-- With The Ignition Switched Off, Disconnect The Battery Ground Cable. Refer To BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the washer fluid reservoir filler neck. Refer to WASHER FLUID RESERVOIR FILLER TUBE, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and the engine compartment E-box cover.

NOTE:

Ignore -Item 1-.

-- Release The Retainers -A Arrows- And Remove The Engine Control Module -Arrow B-.

Fig 2: Engine Control Module (ECM)

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect The Connector -2- If Equipped.

Fig 3: Disconnect Electrical Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -4- and remove the wire -3-.

-- Open the retainers -arrow- and remove fuse panel B -item 1-.

-- Disengage the engine wiring harness on the E-box and free it up.

-- Remove the wire -5-.

Fig 4: Identifying Fuse Panel B Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Relay -3- And Control Modules -4- From Fuse Panel B.

-- Release The Clip -Arrow-, Push The Fuse Panel -2- Back And Out And Disengage It.

-- Release The Clip And Press The Auxiliary Fuse Panel -1- Back And Out.

-- Release The Clips -Arrows- And Press The Relay Panel -2- Back And Out Of The Bracket -1-.

Fig 5: Identifying Retaining Clips

Courtesy of AUDI OF AMERICA, LLC

-- Remove Fuse Panel B From The Engine Compartment E-Box.