Vehicle Electrical System Control Module -J519-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying 3 Pin Relay/Fuse Panel Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn Off The Ignition And Remove The Key.

-- Remove The Driver Side Instrument Panel Cover. Refer To DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Disengage The 3-Pin Relay/Fuse Panel By Pressing The Retaining Springs In The Direction Of The -Arrow- And Remove The Relay/Fuse Panel -1-.

-- Remove The Wire -1- On The 4-Pin Relay/Relay Panel.

Fig 2: Removing Relay/Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Release The Retaining Spring -Arrow A- And Tilt The Relay/Fuse Panel -3- Out Of The Mount -arrow B-.

NOTE:

Ignore -Item 2-.

-- Release The Spring -Arrow- And Remove The Vehicle Electrical System Control Module -J519- -Item 1- Downward From The Mount.

Fig 3: Removing Electrical System Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect The Connectors -2, 5, 6, 7 And 8-.

-- Disconnect The Connectors -3- And -4-.

-- To Disconnect The Connector, Press The Catch -1-, Rotate The Retaining Bracket In The Direction Of The -Arrow- And Remove The Connector.

Fig 4: Catch And Retainer

Courtesy of AUDI OF AMERICA, LLC