Data Bus On Board Diagnostic Interface -J533-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Data Bus On Board Diagnostic Interface -J533-

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove The Glove Compartment. Refer To GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove The Bolt -2-.

-- Pivot The Data Bus On Board Diagnostic Interface -J533- -Item 3- Out Of The Bracket -Arrow-.

-- Disconnect The Connector -4-.

-- Disconnect The Fiber Optic Cable Connector -1-.

-- Seal The Open Wiring Harness Connector -2- For The Fiber-Optic Cable With The Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9 -Item 1-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Protective Cap Prevents Contamination Of Or Mechanical Damage To The Front Surface Of The Fiber-Optic Cable Which Would Impair Signal Transmission.