Data Bus On Board Diagnostic Interface -J533-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Specification. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .

Install In Reverse Order Of Removal. Note The Following:

If the Data Bus On Board Diagnostic Interface -J533- was replaced, then it must be coded again using the Vehicle Diagnostic Tester.

-- Install The Glove Compartment. Refer To GLOVE COMPARTMENT, REMOVING AND INSTALLING .