Hybrid Battery Refrigerant Shut-Off Valve 1 -N516-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation Is Carried Out In The Reverse Order While Observing The Following.

NOTE:

Follow the instructions for installing the O-rings. Refer to REFRIGERANT CIRCUIT SEALS .

Following attachment, check routing of refrigerant lines. They must be inserted in holders provided and not make contact with other components.

-- Replace the O-ring seals. For the correct version. Refer to the Parts Information.

-- Install the union nuts -1 and 2- all the way by hand and then tighten them.

Union nut tightening specification -1 and 2- : 16.5 Nm

NOTE:

Make sure when tightening the union nuts that the refrigerant lines are not tensioned.

-- Evacuate The Refrigerant Circuit And Fill It. Refer To REFRIGERANT CIRCUIT, DISCHARGING WITH A/C SERVICE STATION , REFRIGERANT CIRCUIT, EVACUATING WITH A/C SERVICE STATION , and REFRIGERANT CIRCUIT, CHARGING WITH A/C SERVICE STATION (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Turn On The Ignition.

-- Check the DTC memory for the Climatronic Control Module -J255- display and control head and the A/C Compressor Control Module -J842- and, if necessary, erase the displayed faults using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Observe The Information Regarding Operating The A/C System After Filling. Refer To A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT - 1 , A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT - 2 (Refrigerant R134a, Servicing; A/C System, General Information). After charging the A/C system before activating the A/C system.