Drive Plate With Overload Protection, Checking Run-Out And Adjusting: Notes
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove The A/C Compressor. Refer To A/C COMPRESSOR, REMOVING AND INSTALLING .
-- Clean The Drive Plate Flange -A-.
-- Secure A Dial Gauge -B- Using A Dial Gauge Holder -C- (For Example Using Dial Gauge Holder:VW387 ) On A/C Compressor.
-- Set Probe Of Dial Gauge -D- On Flange Of Drive Plate -A- With A Pre-Tension Of Approximately 1.0 mm.
-- Turn The A/C Compressor Drive Unit -E- A Few Turns.