BELT PULLEY, REMOVING AND INSTALLING, "Denso" A/C COMPRESSOR, VERSION "2": Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace Circlip -A-.

Fig 1: Identifying Circlip And Pulley

Courtesy of AUDI OF AMERICA, LLC

Clean The A/C Compressor Flange Before Sliding On The Belt Pulley.

When Installing The Circlip -A-, Note That It Cannot Be Bent Open More Than Is Necessary For Installation.

-- Install The Belt Pulley -B-.

-- Insert Circlip -A- On Correct Side, The Side With Beveled Insertion Edge -C- Faces Away From A/C Compressor (Install Flat Side Facing Compressor).

-- Insert Rubber Element -D- In Belt Pulley -B- According To Illustration.

-- When Installing Drive Plate, Coat Rubber Element -D- Lightly For Example With Tire Mounting Paste Or Soap Solution (As Sliding Compound).

-- Insert The Drive Plate -C- Far Enough Into Rubber Elements -D- (See Upper Illustration) Until It Contacts A/C Compressor Shaft -B-.

Fig 2: Identifying Drive Plate, Belt Pulley, And Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Install The Drive Plate -C- On The Compressor Shaft -B- By Rotating It In The Direction Of The -Arrow F-.

Fig 3: Identifying Drive Plate, Belt Pulley, And Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Tighten Drive Plate -C- (Above Pulley -D-) To 35 Nm By Turning With A Standard Band Wrench (With Webbing) In Direction Of -Arrow F-, Hold Compressor Shaft -B- With A Standard Socket Wrench.

-- Install Circlip -A- (With Rubber Disc Vulcanized On).