BELT PULLEY, REMOVING AND INSTALLING, "Denso" A/C COMPRESSOR, VERSION "1": Notes

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

A/C COMPRESSOR WITHOUT A/C CLUTCH -N25-

NOTE:

Observe Notes On Replacing Belt Pulley -E-. Refer to OVERVIEW - BELT PULLEY, "Denso" A/C COMPRESSOR, VERSION "1" .

Fig 1: Identifying Belt Pulley Components, Denso Version 3

Courtesy of AUDI OF AMERICA, LLC

Perform Preparatory Work As For Removing Belt Pulley. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

The belt pulley is made of plastic and is sensitive to impact, therefore take special care when handling it.

If the drive plate -C- overload protection activates, rotate the pulley -E- using the outer part of the drive plate -C- so that the compressor shaft -B- and the hexagon head on the drive plate -D- (inner part of the drive plate -C-) do not rotate.