LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1195 (Air Conditioning (A/C Compressor) (Coupe)) >> 87 Air Conditioning >> A/C Compressor >> A/C Compressor Input Shaft, Removing And Installing >> Installing The Input Shaft

Installing The Input Shaft

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

-- Check The Input Shaft -B-, Splines Must Show No Traces Of Wear And Must Be Seated Free Of Play In Splines Of Drive Wheel -C-.

-- Prior To Installation, Coat The Input Shaft Splines -B-, For Example, With Lubricating Grease:G 000 100  .

-- Insert The Input Shaft -B- Before Installing A/C Compressor And Slide It Into Drive Wheel -C- Up To Stop.

Fig 1: Identifying Boot, Drive Shaft & Drive Pinion Splines
GWWA87-0621Courtesy of AUDI OF AMERICA, LLC

-- After Installing A/C Compressor, Check The Position Of The Grommet -A-.

NOTE:

A Clamp On The Power Take-Off Flange Keeps The Grommet -A- From Sliding Off. .

scientia non olet · About LEMON Manuals