Overview - Steering Column Switch Module: Notes
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- The steering column switch module consists of coil connector with slip ring, Steering Angle Sensor -G85-, steering column switch (turn signal indicator switch, wiper switch, cruise control switch) and Steering Column Electronics Control Module -J527-.
- Fault finding is done in "Guided Fault Finding ". Refer to Vehicle Diagnostic Tester.
- Screw
- 0.5 Nm
- Transportation Protection
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138-, Steering Angle Sensor -G85-
- Removing and installing. Refer to Steering Column Electronics Control Module -J527-, REMOVING AND INSTALLING .CAUTION:
Risk Of Damaging The Return Ring.
- The return spring with slip ring must not be turned after removing.
- Pin assignment for the Steering Column Electronics Control Module -J527-. Refer to STEERING COLUMN ELECTRONICS CONTROL MODULE CONNECTOR ASSIGNMENT .
- Mount
- With Turn Signal Switch -E2-, Windshield Wiper Intermittent Mode Switch -E22-
- On vehicles with cruise control with a Cruise control switch -E45-
- Removing and installing. Refer to TURN SIGNAL SWITCH -E2-, REMOVING AND INSTALLING .
- Clamping Ring
- Screw
- 4 Nm
- Steering Column
- Access/Start Authorization Switch -E415-
- Removing and installing. Refer to ACCESS/START AUTHORIZATION SWITCH -E415-, REMOVING AND INSTALLING .
- Trim
- For Access/Start Authorization Switch -E415-
- Removing and installing. Refer to Access/Start Authorization Switch -E415-, REMOVING AND INSTALLING .
- Ignition Key