Access/Start Authorization Switch -E415-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Specification. Refer to Figure.

Install In Reverse Order Of Removal. Note The Following:

-- Install The Gap Cover For The Instrument Cluster. Refer To INSTRUMENT CLUSTER GAP COVER, REMOVING AND INSTALLING .

-- Install The MMI Screen Cover. Refer To MMI SCREEN COVER, REMOVING AND INSTALLING .

-- For USA Vehicles: Install The Right Impact Absorber. Refer To BUMPER / IMPACT ABSORBER, REMOVING AND INSTALLING / INSTRUMENT PANEL CENTRAL TUBE, REMOVING AND INSTALLING .

-- Install The Driver Side Instrument Panel Cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

Connector Assignment For Access/Start Authorization Switch -E415-

Fig 1: Identifying Authorization Switch Connector

Courtesy of AUDI OF AMERICA, LLC

3 - Not Assigned

4 - Not Assigned

5 - S-contact

6 - Terminal 15

7 - LIN

8 - Terminal 30

9 - Not Assigned

10 - Not Assigned

11 - Not Assigned

12 - Not Assigned

13 - RED2, terminal 15

14 - RED, terminal 15

15 - Ignition/starter switch +

16 - Terminal 31