Lane Change Assistance, Preparing For Calibration
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Calibration Tool - Spacing Laser -VAS6350/2-
- For distance measurement
- Usage information. Refer to the Operating Instructions.
- Calibration Unit -VAS6350A-
- Level
- On the Calibration Unit -VAS6350A-
- To check the horizontal position of the Calibration Unit -VAS6350A-
- Catch Bracket
- To mount the Calibration Tool - Spacing Laser -VAS6350/2- for the distance measurement
- Distance to the Calibration Tool - Wheel Center Mountings -VAS6350/1- on the rear wheels: dimension -a- = 1700 ± 2 mm
- Calibration Tool - Wheel Center Mountings -VAS6350/1-
- With wheel bolt adapter and measuring paddle
- Brand Emblem
- The laser point is aligned to the center of the brand emblem
- Calibration Tool - Lane Change Calibration Tool -VAS6350/4-
- Is moved from one side of the measuring field to the other during calibration
- When installed correctly, the vehicle electrical system voltage line must be connected at lower left of the calibration device (as seen in direction of travel)
- Measuring Scale
- For positioning the Calibration Tool - Lane Change Calibration Tool -VAS6350/4-
- Calibration Tool - Linear Laser -VAS6350/3-
- With "laser protective eyewear"
- On the Calibration Unit -VAS6350A-
- Turning on and off. Refer to the Operating Instructions.
- Plastic Foot
- Quantity: 3
- Can be adjusted when setting the horizontal position of the Calibration Unit -VAS6350A-