Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, Calibrating: Procedure

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Assistance Calibration Device VAS 6350/4 Components

Courtesy of AUDI OF AMERICA, LLC

-- Switch on the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- at the voltage switch -3-.

The green LED -1- must turn on.

NOTE:

If the red LED -2- comes on: Check the Calibration Tool - Lane Change Calibration Tool -VAS6350/4-.

-- Continue to follow the instructions in the Vehicle Diagnostic Tester display.

During the program sequence, a request is made to switch the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- from the right to the left side of the Calibration Unit:VAS6350A .

Fig 2: During Course Of Program, A Request Is Made To Switch - VAS 6350/4- From Right To Left Side Of VAS 6350

Courtesy of AUDI OF AMERICA, LLC

-- Switch the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- off and move device.

When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of calibration device (as seen in direction of travel).

Dimension -a- is measured from the upper edge of the calibration device to the floor.

Model		A5/S5 Coupe	A5/S5 Sportback	RS 5 Coupe
Adjustment dimension height in mm dimension -a-	SWA 1.0	700	-	-
	SWA 1.5	700	800	700
	SWA 2.0	759	856	722

-- The indicator on the base of the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- must align with adjustment dimension on the measuring scale -1- on measuring field -arrow-.

Model		A5/S5 Coupe	A5/S5 Sportback	RS 5 Coupe
Left adjustment dimension read in mm on the measuring scale -1-	SWA 1.0	586	-	-
	SWA 1.5	745	690	590
	SWA 2.0	613	670	585

-- Switch on the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- at the voltage switch -3-.

Fig 3: Identifying Assistance Calibration Device VAS 6350/4 Components

Courtesy of AUDI OF AMERICA, LLC

The green LED -1- must turn on.

-- Continue to follow the instructions in the Vehicle Diagnostic Tester display.

-- After calibrating the lane change assistance successfully, end "calibration", switch off the ignition and disconnect the diagnostic connector.