Selector Lever Transmission Range Position Display Unit -Y26-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Selector Lever Transmission Range Position Display Unit, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Shift the selector lever into the "S" position.

-- Turn off the ignition.

-- Carefully pry the selector lever boot out at the side using a Trim Removal Wedge:3409 or a small screwdriver -arrows-.

-- Fold the selector lever boot upward.

-- Release the spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -item 1- -arrow-.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.