Overview - High Beam Assist, Humidity Sensor And Lane Assist
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Front Cover
- for the housing for the Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399-
- Upper Cover
- For Automatic High Beam Assist Control Module -J844-
- Interior Rearview Mirror
- Vehicles with Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399-
- Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399- integrated inside the interior rearview mirror. Cannot be replaced separately if faulty.
- Replacing the interior rearview mirror. Refer to INTERIOR REARVIEW MIRROR .
- Upper Cover
- For Directional Stabilization Assistance Control Module -J759-
- Directional Stabilization Assistance Control Module -J759-
- Removing and installing. Refer to LANE ASSIST .
- Lower Cover
- For Directional Stabilization Assistance Control Module -J759-
- Rear Cover
- Central Connector
- Humidity Sensor -G355-
- There are different versions.
- For vehicles from MY 2010, the Humidity Sensor -G355- is integrated in the Rain/Light Recognition Sensor -G397-
VEHICLES FROM MY 2011
- Removing and installing. Refer to OVERVIEW - COMPONENTS INSIDE FRONT PASSENGER COMPARTMENT .