Front Seat, Moving Into Service Position

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Trim Removal Wedge:3409

Service Position, Implementing

-- Bring headrest into lowest lock position.

-- Move seat as far back and up as possible.

NOTE:

For The Sake Of Clarity, The Figure Does Not Show The Surrounding Area.

Fig 1: Prying Cover Caps From Seat Rail Covers And Seat Fore/Aft Adjustment Spindle With Trim Removal Wedge 3409

Courtesy of AUDI OF AMERICA, LLC

Standard Seat (Manual):

-- Pry the caps -1- off the seat rail -2- using the Trim Removal Wedge:3409 .

Standard Seat (Power):

-- Pry the caps -1- off the seat forward/back adjustment spindle using the Trim Removal Wedge:3409 .

Procedure For All Seat Versions:

Fig 2: Connector Station Rear Cover

Courtesy of AUDI OF AMERICA, LLC

-- Unclip rear cover -1- with the Trim Removal Wedge:3409 and pull the cover in the direction of the -arrow- off of connector station -2-.

NOTE:

Do Not Disconnect Electrical Wires.

Service Position, Resetting

Install In Reverse Order Of Removal.Note The Following:

-- Make sure the cover tab slides into connector station correctly.

-- Engage the cover correctly with the connector station.