Overview - Shift Unit
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The 6-pin connector with backrest lock switch and backrest forward stop switch are not separate from the bracket. They are delivered as a >>micro-switch with bracket<< switch unit -item ) OVERVIEW - SHIFT UNIT - Switch Unit (Micro-Switch With Bracket).
The locking bushing -item ) OVERVIEW - SHIFT UNIT - Locking Bushing and the screws for securing the switch unit -item ) OVERVIEW - SHIFT UNIT - Bolt are delivered as a replacement part.
The Backrest Is Shown Without The Cushion, Cover And Lower Seat Frame.
- Backrest Frame
- Bolt
- 1.5 Nm
- Quantity: 2
- Washer
- Nut
- Tightening specification. Refer to -item ) OVERVIEW - BACKREST ADJUSTMENT MOTOR - Nut.
- Always replace
- Shaft
- The threads must always be cleaned before installing the nut -item ) OVERVIEW - SHIFT UNIT - Nut (for example, using a thread tap).
- Coat the threads on the shaft with locking fluid before installing the nut. For the correct locking fluid.
- Locking Bushing
- Clipped to the spindle
- Clip to the spindle after adjusting the switch unit
- Switch Unit (Micro-Switch With Bracket)
- Removing and installing. Refer to BACKREST ADJUSTMENT MOTOR AND SWITCH UNIT, REMOVING AND INSTALLING .
- Adjusting. Refer to MICRO SWITCH, ADJUSTING, BACKREST LOCK SWITCH .
- Checking. Refer to MICRO SWITCH, CHECKING, BACKREST LOCK SWITCH .