Entry Assistance Trim, Removing And Installing, Power Standard Seat: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Press the handle -arrow B- forward as far as the stop and hold it in that position.

Fig 1: Identifying Entry Assistance Trim

Courtesy of AUDI OF AMERICA, LLC

-- Press the tab -arrow A- off the fastener -arrow C- in the direction of the -arrow- using a Trim Removal Wedge:3409 .

-- Perform the same step on the opposite side of the trim -1-.

-- Tilt the trim -1- upward diagonally and remove from the handle with the bracket -2-.

-- Disengage the rear trim catch from the handle with bracket.

-- Remove the trim -1- from the handle with bracket -2- as far as the length of the entry assistance button wire allows.

-- Disconnect the electrical connector -1- on the entry assistance button -2-.

Fig 2: Identifying Entry Assistance Button

Courtesy of AUDI OF AMERICA, LLC

-- Remove the trim -3- with the entry assistance button.

-- Remove the entry assistance button. Refer to ENTRY ASSISTANCE BUTTON, REMOVING AND INSTALLING .