Locking Mechanism Trim, Removing And Installing, Locking Mechanism Without Lock Cylinder: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clipping On Center Rear Of Trim Must Be Destroyed After Removing Trim With Lock Cylinder

Courtesy of AUDI OF AMERICA, LLC

-- Guide the front clips -arrow- under the cover.

-- Make sure the cover is covered by the rear part of the trim -1-.

-- Press the front of trim -1- down until the clips -arrows- engage audibly in the retainer.

-- Press the section of trim -1- marked with an -arrow- down at an angle until the center rear clip engages audibly in the retainer.

Fig 2: Pressing Section Of Trim -1- Marked With An -Arrow- Down At An Angle Until Center Rear Clip Engages Audibly In Retainer

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Illustration Shows Trim With A Lock Cylinder.

The Trim -1- Is Seated Securely Once It Engages Audibly With The Retainer.

-- Make Sure The Button -2- Moves Easily After Installing The Trim.