Lock Cylinder, Removing And Installing, Pass-Through Door Handle: Installing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
CAUTION:
- Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.
- Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.
-- Slide The Lock -3- Into The New Lock Cylinder -2- Correctly.
-- Remove the protective cap -4- from the new lock cylinder -2-.
-- Insert the lock cylinder -2- in the correct installation position into the pass-through handle -1-.
-- Turn the key 90° clockwise.
- Installation Position Of The Lock Cylinder: The Key Slot Must Be Vertical And The Retaining Tab -Arrow- Must Point To The Right, Opposite The Direction Of Travel.