Memory Seat/Steering Column Adjustment Control Module Bracket, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer To SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Remove the memory seat adjustment/steering column adjustment control module. Refer To MEMORY SEAT/STEERING COLUMN ADJUSTMENT CONTROL MODULE, REMOVING AND INSTALLING .

-- Press the pin -2- toward the padding and out of the clip -arrow A- on the bracket -1-, for example using an upholstery needle.

Fig 1: Bracket -1- & Pin -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the pin -2- from the seat pan.

-- Remove the bracket support base -2- from the seat pan upper frame.

Fig 2: Bracket -2-

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the clip -arrow A- at the seat pan upper frame -1-.

-- Disengage the retaining tabs -arrow B- (quantity: 2).

-- Carefully remove the bracket from the lower seat frame in the direction of the -arrow-.

-- Remove the bracket from the seat pan.