Side Trim Panel, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note The Following:
NOTE:
If Any Clamps And Clips Remain In The Body, Remove Them And Insert Them In The Trim.
Check clamps and securing clips for damage or deformation, replace if necessary.
-- Thread the belt webbing with seat belt latch through the belt extraction panel.
-- Install the rear belt anchor. Refer to REAR OUTER BELT END FITTING, REMOVING AND INSTALLING .
-- Position the side trim and press it on until all the mounting points engage.
-- Stretch the door seal lip over the side trim.