Battery, Charging With Battery Charger :Vas5095A: Procedure

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn Off The Ignition And All Electrical Consumers And Remove The Ignition Key.

-- Check The Battery Type Setting On The BATTERY TYPE Switch. Refer To BATTERY CHARGER . The BATTERY TYPE Switch Must Be Set To 2.4V/C (Volts/Cell) .

-- Connect The Red Charge Terminal (+) To The Positive Terminal Of The Battery -A-.

NOTE:

On Vehicles With A Start/Stop Function And An Installed Battery Monitoring Control Module -J367-, The Black Charge Terminal (-) Must Be Connected To The Body Ground. The Start/Stop System Will Malfunction When It Is Connected To The Battery -A- Negative Terminal.

-- Connect The Black Charge Terminal (-) To The Negative Terminal Of The Battery -A- /Negative Connector.

-- Switch On The :VAS5095A . Refer to BATTERY CHARGER .

Charge Current Displays. Refer To Figure -2- And -3- Light Up Yellow. The Battery -A- Is Partially Charged (Approximately 90 %) When Only The Yellow LED -3- is on.

If The Green LED. Refer To Figure -4- is also on, then the :VAS5095A Has Switched To Maintenance Charging. The Battery -A- Is Charged.

-- Switch off the :VAS5095A . Refer to BATTERY CHARGER .

-- Remove The Charging Clamps From The Battery Terminals.