Airbag Control Module -J234-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .

-- Turn on the ignition.

-- Versions with a selector lever: move the selector into 'S'.

-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Remove the bracket for the center console. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .

-- Remove the rear air guide. Refer to appropriate service information. .

Fig 1: Identifying Airbag Control Module

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Fold up the floor covering over the airbag control module. Cut the floor covering along the perforation if necessary.

-- Slide the retainer -7- on the connector in the direction of the -arrow-.

-- Press the release button -6-, opening the retainer -5- on the connector and remove the connector -4-.

-- Remove the nuts -1 through 3- and remove the airbag control module -A- from the threaded pins.