LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1042 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Hood, Removing And Installing >> Front Hood Seal, Removing And Installing >> Procedure

Front Hood Seal, Removing And Installing: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plenum Chamber Seal
    • To remove, pull forward on the side off the body flange.
    • Mount the seal on the foam piece and then push it onto the flange on the body.
    • Mount the seal on the opposite side with pretension on the side on the foam piece and push it onto the body flange.
    • Press the seal on the opposite side in steps on the body flange using up any overlap along the body flange.
  2. Right Sealing Profile
    • To remove, unclip it from the fender flange and the suspension strut tower.
    • Press the clips on the foam piece into the body when installing.
  3. Plenum Chamber Bulkhead
    • Slide the plenum chamber seal on at the sides.
scientia non olet · About LEMON Manuals