EVAP Canister, Removing And Installing, Except AUDI A6 Hybrid: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
-- Remove the rear left underbody trim panel. Refer to UNDERBODY TRIM PANEL .
-- Remove the breather line -1-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, SEPARATING .
-- Disconnect the ventilation line -3- to the fuel tank. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, SEPARATING .
-- Remove the breather line -5- to the EVAP Canister Purge Regulator Valve 1 -N80-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, SEPARATING .
-- Remove the bolts -2, 4 and 6- and remove the EVAP canister.