Crankshaft Seal, Replacing, Transmission Side
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Crankshaft Seal Installer Kit :T10122B
- Seal Installer - Crankshaft :T10122/1
- Seal Installer - Crankshaft - Pull Sleeve :T10122/2
- Seal Installer - Crankshaft - Thrust Piece :T10122/3
- Puller - Crankshaft/Power Steering Seal :T20143/2
- Transmission removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING [7-SPEED DUAL CLUTCH TRANSMISSION 0CJ, 0CL, 0CK, 0DN, 0DP] and/or TRANSMISSION, REMOVING [7-SPEED DUAL CLUTCH TRANSMISSION 0CK] or TRANSMISSION, REMOVING [8-SPEED AUTOMATIC TRANSMISSION 0BK AWD] .
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Pry out the shaft seal using :T20143/2 .
-- Clean the running and sealing surface.
-- Place the :T10122/1 on the :T10122/2 and slide the shaft seal -A- onto the pull sleeve.
-- Remove the assembly device.
-- Position the pull sleeve :T10122/2 with shaft seal -1- on the crankshaft.
-- Install the shaft seal in evenly all around with :T10122/3 until flush.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .