Impact Member, Removing And Installing, Vehicles Through My 2011: Removing
NOTE:
When installing, bring all cable ties back to same positions.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
-- Disconnect the electrical connector -4- on the horns and free up the electrical wiring harness -3- on the horn bracket.
-- Free up the washer nozzle water drain hose by disconnecting the cable tie -1-.
-- Remove the bolts -arrows- and the bumper cover spacer -2-.
-- Remove the impact bar -5- from the mounts.
NOTE:
Pry the impact bar out of the mounts if it is not easy to remove.