Vibration Damper Seal, Replacing: Procedure

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

• The :T10531/2  is installed.

-- Remove the seal -arrow- with the :T40274  .

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the :T10354  .

Courtesy of AUDI OF AMERICA, LLC

• The closed side of the seal points to the :T10354  .

-- Push the seal -arrow- with the :T10354  on the :T10531/2  and place on the lower timing chain cover.

Courtesy of AUDI OF AMERICA, LLC

-- Additionally attach the :T10375  and tighten the :T10531/4  .

Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the :T10354  .

Further installation is performed in reverse order of removal, while noting the following:

• Replace the bolt with O-ring for the vibration damper after removal.

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .