Tightening Specifications

Fig 1: Tightening Sequence Bearing Bracket

Courtesy of AUDI OF AMERICA, LLC

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 7-	Install by hand all the way
2.	-1 to 6-	9 Nm
3.	-7-	M6: pretension to 8 Nm M8: pretension to 20 Nm
4.	-7-	90° additional turn

Fig 2: Three Stage Chain Sprocket Installation Position

Courtesy of AUDI OF AMERICA, LLC