New Connecting Rod, Separating
New connecting rods might not be completely separated at the predetermined breaking point. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:
-- Mark the cylinder where the connecting rod is allocated to -item ) OVERVIEW - PISTONS AND CONNECTING ROD.
-- Lightly clamp the connecting rod -1- in a vise equipped with aluminum protective pads.
- Clamp the connecting rod lightly to prevent damaging it.
- Clamp the connecting rod below the dotted line.
-- Loosen both bolts -2- approximately five turns.
-- Carefully tap the connecting rod bearing cap -1- with a plastic hammer in the direction of -arrow- until it comes loose.