Sub-Assembly Bracket, Removing And Installing: Installing
Install In Reverse Order Of Removal And Note The Following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Replace the O-ring and seals after removing.
- Used coolant cannot be used again.
-- Coat the new O-rings -4- with coolant additive.
-- Insert the connection -2- into the coolant pump housing -3-.
-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts.
-- Install the oil filter. Refer to ENGINE OIL, EXTRACTING AND REPLACING OIL FILTER (CABRIOLET) / ENGINE OIL, FILLING AND CHECKING LEVEL (CABRIOLET)
There are additional procedures depending on the model. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING / CYLINDER BLOCK, BELT PULLEY SIDE .