Engine Coolant Temperature Sensor -G62-, Removing And Installing: Removing

-- Loosen the hose clamps -arrows- and remove the air duct hose.

Fig 1: Air Intake Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Remove the intake manifold support; to do so, remove the nut -2- and bolt -1-.

Fig 2: Identifying Intake Manifold Support, Nut And Bolt

Courtesy of AUDI OF AMERICA, LLC

All additional procedures are described. Refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING .