Part III: Notes

Part I.  Refer to OVERVIEW - TURBOCHARGER .

Part II.  Refer to OVERVIEW - TURBOCHARGER .

Part IV  - 1.8L engine only. Refer to OVERVIEW - TURBOCHARGER .

Fig 1: Exploded View Of Turbocharger With Components & Brackets (Coolant Line)

Courtesy of AUDI OF AMERICA, LLC

1. Gasket
   • Always replace after removing
2. Nut
   • Tightening sequence. Refer to appropriate service information. .
   • Always replace after removing
   • Coat the exhaust manifold stud bolts with hot bolt paste. Refer to the Parts information for the hot bolt paste.
3. Bolt
   • 35 Nm
4. O-ring
   • Always replace after removing
5. Coolant Return Line
6. Bolt
   • 9 Nm
7. Turbocharger
   • Can only be replaced with exhaust manifold and vacuum diaphragm.
   • Removing and installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING 
8. Bolt
   • 30 Nm
9. Bracket
10. Support
11. Bolt
    • 30 Nm
12. Bolt
    • 30 Nm
    • Coat the bolt with hot bolt paste. Refer to the Parts information for the hot bolt paste.
13. Nut
    • 30 Nm
    • Always replace after removing
    • Do not open when removing the turbocharger
    • Coat the exhaust manifold stud bolts with hot bolt paste. Refer to the Parts information for the hot bolt paste.
14. Clamping Strip