Overview - Instrument Cluster
NOTE:
All warning lamps in instrument cluster are fitted with light-emitting diodes. In case an indicator lamp is malfunctioning, the instrument cluster must be replaced.
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to OIL LEVEL THERMAL SENSOR -G266-, REMOVING AND INSTALLING[For engine(s) CAED, CAEB, CPMB, CPMA] .
- Oil Pressure Switch -F1-
- Removing and installing. Refer to Oil Pressure Switch -F22-, REMOVING AND INSTALLING [For engine(s) CAED, CAEB, CPMB, CPMA] .
- Connector
- For Data Bus On Board Diagnostic Interface -J533-
- Data Bus On Board Diagnostic Interface -J533-
- Overview. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Bolt
- Tightening specification. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Fiber Optic Cable Connector
- Seal with Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Removing and installing. Refer to Instrument Cluster -KX2-, REMOVING AND INSTALLING .
- Multi-pin connector pin assignment. Refer to INSTRUMENT CLUSTER MULTI-PIN CONNECTOR CONTACT ASSIGNMENT .
- Connector
- For instrument cluster
- Bolt
- 2.5 Nm
- Gap Cover
- Removing and Installing. Refer to STORAGE COMPARTMENTS AND COVERS .
- Bolt
- 2.5 Nm
- Bolt
- 2.5 Nm
- Fuel Level Sensor -G-
- Connector assignment. Refer to Fuel Level Sensor -G- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to appropriate service information. .
- Fuel Level Sensor 2 -G169-
- Connector assignment. Refer to Fuel Level Sensor 2 -G169- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to appropriate service information.
- Radio Frequency Controlled Clock Receiver -J489-
- Removing and installing. Refer to RADIO FREQUENCY CONTROLLED CLOCK RECEIVER, REMOVING AND INSTALLING .
- Bolt
- 2.5 Nm
- Bolt
- 2.5 Nm
- Connector
- for Radio Frequency Controlled Clock Receiver -J489-
- Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .
- Brake Pad Wear Sensor
- Left Front Brake Pad Wear Sensor -G34-
- Removing and Installing. Refer to appropriate service information. .
- Brake Fluid Level Warning Switch -F34-
- Removing and Installing. Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER .
- Engine Coolant Level Warning Switch -F66-
- Connector
- For Outside Air Temperature Sensor -G17-
- Outside Air Temperature Sensor -G17-
- Removing and installing:
- Vehicles through MY 2012. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING .
- Vehicles from MY 2013. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING
- Removing and installing: