LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Premium Plus >> Repair and Diagnosis >> Brakes >> Hose, Tubing, Fittings & Reservoirs >> Mechanical Components - Brake System (Cabriolet) >> 46 Mechanical Components >> Rear Brakes >> Brake Shield, Removing And Installing >> Installing

Brake Shield, Removing And Installing: Installing

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the rear brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure that the brake hose is clipped in and mounted correctly on the combination bracket on the stub axle carrier. This is so that the brake hose does not jump out of the bracket by itself.

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL, CHANGING AND MOUNTING / WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower The Vehicle.

scientia non olet · About LEMON Manuals