Brake Caliper, Removing And Installing: Installing
Clean Bolts Before Reusing
Replace Damaged Bolts
Always replace self-locking bolts.
-- Carefully press the brake caliper with the brake carrier and the installed brake pads over the brake rotor.
Clean Bolts Before Reusing
Replace Damaged Bolts
Always replace self-locking bolts.
-- Tighten the brake carrier with bolts -16 and 17-.
Use an extension to tighten the lower screw -16-. An extension is not needed to tight the upper screw -17-. Slightly move the wheel housing liner away.
-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.
Make sure that the brake hose is clipped in and mounted correctly on the combination bracket on the stub axle carrier. This is so that the brake hose does not jump out of the bracket by itself.
-- Install The Wheels.
-- Lower The Vehicle.
Wheel bolt tightening specification. Refer to WHEEL, CHANGING AND MOUNTING / WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Switching on the ignition
Displayed on the Vehicle Diagnostic Tester display
- The request to enter a display group number appears in display field -1-.
- An entry keypad is shown in display field -2-.
-- Using the entry keypad, enter in the display field -2- "006" for the "display group number" and confirm by pressing the Q button. (Guide pistons together).
-- To exit the entry template, press the green arrow button on the lower left.
DTC memory checked, errors shown corrected and DTC memory erased.
-- With the ignition switched off, remove the Vehicle Diagnostic Tester from the diagnostic socket in the vehicle.