Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Removing

NOTE:

Ignition on

Release parking brake

DTC memory checked, errors shown corrected and DTC memory erased.

Ignition off.

-- Raise The Vehicle.

-- Remove the wheels.

NOTE:

Ignition must be switched off for at least 30 seconds when disconnecting connector!

Clean the entire area around the connector and actuator/brake caliper.

Disconnect the actuator connector -1-.

Fig 1: Disconnecting Actuator Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove both actuator bolts -1-.

Fig 2: Identifying Actuator Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the actuator in the direction of the -arrow-

Fig 3: Identifying Actuator

Courtesy of AUDI OF AMERICA, LLC

-- Remove sealing ring with a suitable tool.

Fig 4: Identifying Sealing Ring With Suitable Tool

Courtesy of AUDI OF AMERICA, LLC

Make sure that ring groove of the seal and contact surface of parking brake actuator do not become damaged.

NOTE:

Do not use any tools with sharp edges.

-- Clean ring groove and contact surfaces if dirty. Only use brake cleaner.