Brake Pads, Removing And Installing, 1LT And 1LY: Removing

-- Raise The Vehicle.

-- Remove the wheels.

NOTE:

Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.

-- Remove the caps -13-.

Fig 1: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.

-- Lift the securing strap slightly at bottom of connector and then rotate 90°.

-- Remove the lower section of the brake pad wear indicator connector from the bracket.

-- Using the screwdriver, pry off the brake pad spring from the brake caliper housing and remove.

Fig 2: Identifying Brake Pad Retaining Spring From Brake Caliper Housing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove both guide pins -12- from the brake caliper.

Fig 3: Identifying Caliper Guide Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

Mount the brake caliper on the vehicle using a suitable wire. Do not support the weight with the brake hose.

-- Remove the brake pad from the brake caliper housing or from the brake carrier.