Brake Caliper, Replacing, 1LT And 1LY: Installing

NOTE:

Clean Bolts Before Reusing

Replace Damaged Bolts

Always replace self-locking bolts.

-- Position the brake carrier.

-- Tighten the brake carrier with bolts -5-.

Fig 1: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake hose into the brake caliper and tighten.

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

-- Remove the :VAG1869/2 .

NOTE:

Only bleed the brakes on the wheel which had the brake caliper replaced.

-- If there is insufficient brake pressure, bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After inserting the brake pads and before driving for the first time, press the brake pedal firmly several times while parked so that brake pads are properly seated in their corresponding operating position.

-- Check brake fluid level, and fill if necessary.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.