Brake Caliper, Replacing, 1LA, 1LB, 1LJ And 1LD 1ZT + S4 /S5: Installing

NOTE:

Clean Bolts Before Reusing

Replace Damaged Bolts

Always replace self-locking bolts.

-- Position the brake carrier.

-- Tighten the brake carrier with bolts -3-.

Fig 1: Identifying Brake System Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Before installing the brake pads, clean the brake pad bolt -arrows- and apply a thin coat of grease. Refer to Parts Information.. When doing this, do not allow any grease to get on the rubber components. Clean the rubber components of grease.

Fig 2: Identifying Retaining Pins

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LA, 1LB, 1LJ AND 1LD 1ZT + S4 /S5 .

-- Install the brake pressure line -5- in the brake caliper and tighten.

Fig 3: Identifying Brake System Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :VAG1869/2 .

NOTE:

Only bleed the brakes on the wheel which had the brake caliper replaced.

-- If there is insufficient brake pressure, bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After inserting the brake pads and before driving for the first time, press the brake pedal firmly several times while parked so that brake pads are properly seated in their corresponding operating position.

-- Check brake fluid level, and fill if necessary.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.