Brake Pedal, Attaching To Brake Booster

Fig 1: Exploded View Of Brake Pedal Assembly With Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Do not destroy the brake pedal stop -17-. There is the danger that the brake lamp sensor mount -10- could break when the brake pedal is released.

-- Hold the ball head of pushrod in front of the mount and push the brake pedal in direction of brake booster, so the ball head locates audibly.

Fig 2: Brake Pedal, Joining To Brake Booster

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake lamp sensor. Refer to BRAKE LAMP SENSOR, REMOVING AND INSTALLING .

-- Install the footwell vent -A-.

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- on the footwell vent.

-- Install the driver side storage compartment -1 to 3-.

Fig 4: Identifying Driver Side Instrument Panel Cover

Courtesy of AUDI OF AMERICA, LLC