Driver/Front Passenger Seat Heating Element - Z6- / - Z8-, Removing And Installing, Bucket Seat: Installing

-- Align the new heating elements on the seat surface.

CAUTION:

Make sure the new seat heating element is affixed to the old heating element.
Remove the protective films in the bonding sequence for the heating element area.
When removing the protective films, make sure the heating element is not damaged and that it is attached without wrinkles.

-- Guide the electrical wire downward through the opening provided in the seat cushion.

-- Remove the protective film and adhere the new heating elements -1, 2, 3, 4 and 6- to the cushion in the same position as the old heating elements.

-- Run connecting wires -A- without tension to the seat bolsters along the bottom of the gaps.