Overview - Pedal Assembly
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Functional impairment
- The amount of clutch and brake pedal travel must not be decreased by additional floor mats.
NOTE:
Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
Make sure that no brake fluid escapes into the footwell or into the plenum chamber or onto the transmission below. If it does, clean the area thoroughly.
- Bracket
- With the brake pedal
- Removing and installing. Refer to CLUTCH MASTER CYLINDER, REMOVING AND INSTALLING .
- Bearing Bushing
- Clutch Pedal
- Removing and installing. Refer to CLUTCH MASTER CYLINDER, REMOVING AND INSTALLING .
- Clutch Pedal Stop
- Mounting Pins
- For the clutch master cylinder
- Lubricate the bearing area
- Clutch Pedal Mounting Axle
- Bearing Shell
- Located in the clutch pedal
- Over-Center Spring
- Black side faces toward clutch pedal
- Note the different bearing position in the mounting bracket. Refer to "Over-Center Spring Installation Position" in INSTALLING THE OVER-CENTER SPRING .
- Removing and installing. Refer to OVER-CENTER SPRING, REMOVING AND INSTALLING .
- Bearing Shell
- Note the different bearing position in the mounting bracket. Refer to "Over-Center Spring Installation Position" in INSTALLING THE OVER-CENTER SPRING .
- Seal
- Replacing
- Clutch Master Cylinder
- Removing and installing. Refer to CLUTCH MASTER CYLINDER, REMOVING AND INSTALLING .
- Lubricating the bearing lug for the pressure rod
- Clutch Position Sensor -G476-
- Integrated Clutch Pedal Switch -F36- and Clutch Pedal Starter Interlock Switch -F194-
- Can only be replaced together with the clutch master cylinder, refer to -item 11-.