Clutch Module Overview
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Service the clutch module -2-. Refer to Description and Operation .
- A - Alignment Pins
- Not equipped for all vehicles; completely omitted from approximately September 2007
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.
- B - Alignment Bore
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.CAUTION:
The clutch will not function properly if it is not installed correctly.
- The clutch may have noticeable function problems if the alignment pins for the drive plate -A- are not inside the hole in the clutch module -B-.
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.
- 1 - Drive Plate
- On 4-cylinder engines - 3 holes with threaded sleeves
- With 6- and 8-cylinder engines - 6 holes with threaded sleeves
- With needle bearing
- Removing and installing, refer to the appropriate service information
- 2 - Clutch Module
- With transfer plate
- Components: dual mass flywheel, clutch plate and clutch pressure plate
- Removing and installing, refer to Removal and Installation
- Servicing, refer to Description and Operation
- 3 - Bolt
- 60 Nm
- For mounting the dual flywheel to the drive plate
- Quantity: three on a 4-cylinder engine
- Quantity: 6 with 6- and 8-cylinder engines
- Always replace.
- Follow the tightening sequence, refer to CLUTCH MODULE TO DRIVE PLATE, TIGHTENING SEQUENCE .