Overview - Coolant Pump/Coolant Thermostat
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- O-rings
- Always replace after removing
- Connection
- Clip
- Only with the attached version
- Check for secure fit
- Bolt
- 4 Nm
- Only with the bolted version
- Retaining Plate
- Only with the bolted version
- Engine Coolant Temperature Sensor -G62-
- Removing and installing. Refer to Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING
- O-ring
- Always replace after removing
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING
- For a new coolant pump, remove the protective cap
- Seal
- Always replace after removing
- Centering Pin
- Quantity: 2
- Toothed Belt
- For the coolant pump
- Removing and installing. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING
- Toothed Belt Guard
- Bolt
- 9 Nm
- Bolt
- 10 Nm + 90°
- Always replace after removing
- Left-hand thread
- Toothed Belt Sprocket
- Note the installation position
- Exhaust Side Balance Shaft Seal
- Replacing. Refer to BALANCE SHAFT GASKET, REPLACING, INTAKE SIDE .
- Balance Shaft
- Coolant Thermostat
- Removing and installing. Refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING
- Checking. Refer to COOLANT THERMOSTAT, CHECKING .
- Centering Pin
- O-ring
- Always replace after removing
- Connection
- Bolt
- 9 Nm
-- Tighten the coolant pump bolts to 9 Nm in a -1 to 5- sequence.