Intermediate Sprocket Tightening Sequence

NOTE: There Is a Risk of Destroying the Engine When the Intermediate Sprocket Is Missing Backlash.

The new intermediate sprocket has an anti-friction coating that wears off after a short period of use, which automatically adjusts the backlash.

Replace the bolts that were tightened with an additional turn after removing them.

Courtesy of

INTERMEDIATE SPROCKET TIGHTENING SEQUENCE

Step	Tightening Specification/Additional Turn
1.	10 Nm
2.	Turn the intermediate sprocket. The intermediate sprocket must not have any play otherwise loosen and tighten it again
3.	25 Nm
4.	90° additional turn