Overview - Front Brake Caliper, FBC, 1LA And 1LJ Brake Caliper
NOTE:
Install complete repair kit when servicing.
Apply thin coat of Assembly Paste G 052 150 A2 to brake cylinders, pistons and seals.
- Bolt
- 30 Nm
- Protective Cap
- Insert in brake caliper
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Guide Pin
- Slide through the boot
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Protective Cap
- Install on the bleeder valve.
- Bleeder Valve
- 15 Nm
- Apply a thin coat of Assembly Paste G 052 150 A2 to the threads before screwing in.
- Brake Caliper Housing
- Spring
- Ensure installation position is correct.
- Protective Cap
- Do not damage when installing piston
- Coat with Assembly Paste G 052 150 A2.
- Piston
- Apply thin coat of Assembly Paste G 052 150 A2 to piston before inserting
- Diameter 57 mm.
- Seal
- Coat with Assembly Paste G 052 150 A2.
- Brake Carrier
- Removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LA, 1LB, 1LJ AND 1LD 1ZT + S4 /S5 .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- Bolt
- 196 Nm