Bearing Bushing And Guide Pin, Replacing, FBC, 1LA And 1LJ Brake Caliper: Removing

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

-- Press the retaining spring -7- in the center.

Fig 1: Exploded View Of Brake Caliper

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The spring is tensioned, keep hands protected.

When removing the spring, make sure it does not scratch the brake caliper or damage the paint.

-- Remove the retaining spring carefully.

-- Remove the bolts -1- on the brake caliper.

-- Remove the brake caliper.

Do not let the brake caliper hang from the brake hose. Secure it to the body with suitable cable ties or wire. Do not support the weight with the brake hose.

-- Remove the protective cap -2- on the outside from the groove on the guide pin.

Fig 2: Exploded View Of Brake Caliper

Courtesy of AUDI OF AMERICA, LLC

-- Pull the guide pin -3- outward out of the protective cap.

-- Remove the protective cap from the brake caliper.