Bearing Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the bolts -arrows- and tighten them. Tightening specifications -item 4- OVERVIEW - CYLINDER HEAD.

Courtesy of AUDI OF AMERICA, LLC

-- Coat the holes -arrows- with engine oil.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the adapter sleeve -1- is installed.

Courtesy of AUDI OF AMERICA, LLC

Carefully mount the bearing bracket without tilting it.

-- Attach the bearing mount and install the bolts -arrows- all the way by hand.

-- Remove the :T40267 .

-- Tighten the bearing bracket bolts. Refer to Figure.

Installation is performed in reverse order of removal, noting the following:

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .